Ir2110 Mosfet Drivers For Mac
Hello Zuhaib, It's a bit difficult to read the details in the photo snapshot that you provided, but we assume that the serial resistor is 10 Ohms. You used the additional diode to do the discharging faster, correct? You can check your circuit against the typical one here on page 1.You don't have a cap at Vss and Vdd.The MOSFET needs to be connected with Pin 5. This line is missing in your circuit; therefore, the MOSFET has no potential.The cap at the MOSFET drain to ground is missing.Please consider that cable or connectors can have influences. Wires should be quite short. Please check with an oscilloscope if the gate charge and the timing are ok. Check here: and see chapter 2.1 For timing, see page 3 (Ton,toff,etc) and figure 4 see page 6.